Lexmark OptraImage 232 - Manual (Page 6)

6 OptraImage Setup Guide
Step 2: Install the MarkNet print
server
CAUTION! Before installing the
MarkNet N2501e print server in your
printer, make sure the fax/phone cable
is not plugged into the card or the wall
outlet. Make sure your printer is
unplugged.
If your printer shipped with the MarkNet N2501e or N2401e
print server already installed, skip to the next step.
Install the MarkNet N2501e or N2401e print server in an
available optional card slot inside your printer. (MarkNet
internal print servers are sometimes called printer option
cards.)
For detailed instructions about installing your print server,
refer to your printer setup documentation.
See “Safety information” on page 4 for
additional caution information.
MarkNet N2501e print server ports
SCSI port (OptraImage scan
unit attaches here) Ethernet 10/100
port (uses RJ-45
cable) Fax Modem
port (uses RJ-
11 cable)
MarkNet 2401e print server ports
SCSI port (OptraImage scan
unit attaches here) Ethernet 10/100
port (uses RJ-45
cable)