Lynx L-210 - Manual (Page 28)

28
default DHCP configuration, you should be able to Ping the network address 192.168.1.1. If your
ISP has provided their server address you can try to ping the address. If the pings for both the
WAN and the LAN side complete, and you have the proper protocols configured, you should be
able to surf the Internet.
By default when you select ping test, the Lynx L-210 will ping itself 3 times. As shown in Figure 20,
the Lynx L-210 passed the Ping test; this basically means that the TCP/IP protocol is up and
running. If this first Ping test does not pass, the TCP/IP protocol is not loaded for some reason; you
should restart the Lynx L-210.
Figure 20 (Ping test)
4.7.5 Modem Test
The Modem Test is used to check whether your Lynx L-210 is properly connected to the WAN
Network. This test may take a few seconds to complete. To perform the test, select your connection
from the list and press the Test button. Before running this test, make sure you have a valid DSL
link; if the DSL link is not connected, this test will always fail.
Also the DSLAM must support this feature; not all DSLAMs have F4 and F5 support.
4.8 Status
The Status section allows you to view the Status/Statistics of different connections and interfaces
4.8.1 Network Statistics
Select to view the Statistics of different interfaces - Ethernet/USB/DSL.
4.8.2 Connection Status
Select to view the Status of different connections.