Lincoln Electric IDEALARC CV-400-I - Manual (Page 37)

F-9 DIAGRAMS F-9
CV-400-I
K867 UNIVERSAL ADAPTER INSTALLATION AND CONNECTION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
THIS CONNECTOR IS MEANT TO BE USED WITH LINCOLN POWER SOURCES WHICH HAVE A 14-PIN
TO ANY OF THE 14 CIRCUITS PRESENT IN THE WIRE FEEDER RECEPTACLE.
WIRE FEEDER RECEPTACLE. IT IS DESIGNED TO ALLOW THE USER TO MAKE CONNECTIONS
CONSULT THE WIRING DIAGRAM OF THE POWER SOURCE AND WIRE FEEDER THIS ADAPTER WILL BE USED WITH.
2. CONSULT THE APPROPRIATE EQUIPMENT WIRING DIAGRAMS FOR THE CONNECTIONS TO UNIVERSAL ADAPTER.
THE STANDARD CONNECTOR PIN DESIGNATIONS AND FUNCTIONS ARE SHOWN BELOW.
MAY OR MAY NOT BE ISOLATED, INDEPENDENT CIRCUITS INSIDE THE WELDER.
3. USE LUG, CRIMP SPLICE OR SOLDER CONNECTIONS AS REQUIRED AND INSULATE EACH USED AND UNUSED LEAD
14-PIN BOX RECEPTACLE, FRONT VIEW
AND 14-PIN CABLE PLUG, REAR VIEW
14-PIN BOX RECEPTACLE, REAR VIEW AND 14-PIN CABLE PLUG, FRONT VIEW
K=42
A=32
B=GND
C=2 L=82
D=4
E=77
M=81
F=76
G=75
N=SPARE
H=21
I=41
J=31
K=42
J=31
I=41
H=21 N=SPARE
G=75
F=76
M=81
E=77
D=4
C=2
L=82 B=GND
A=32
PIN
SPARE
WELDING MODE CONTROL
A B C D E F G H I J K L M N
81 8242 31 41 21 75 76 77 4 2
GND 32
LEAD
WELDING MODE CONTROL STANDARD FUNCTION 24V AC 42V AC 115V AC 42V AC WORK OUTPUT CONTROL OUTPUT CONTROL OUTPUT CONTROL TRIGGER CIRCUIT TRIGGER CIRCUIT CHASSIS CONNECTION 115V AC
NOTE: 115V AC (31, 32), 42V AC (41, 42), 24V AC (SPARE) AND TRIGGER CIRCUIT (2, 4)
1. TURN THE POWER SWITCH OF THE WELDING POWER SOURCE OFF BEFORE INSTALLING
THIS ADAPTER TO WIRE FEEDER CABLE.
(SEE APPROPRIATE WIRING DIAGRAM) THESE FUNCTIONS ARE LISTED FOR REFERENCE ONLY AND EACH MAY OR MAY NOT BE PRESENT IN YOUR EQUIPMENT.
NOT ALL CIRCUITS ARE PRESENT IN EVERY POWER SOURCE, NOR ARE THEY REQUIRED FOR PROPER WIRE FEEDER OPERATION.
IN THE UNIVERSAL ADAPTER. THE INSULATING METHOD MUST BE RATED FOR 120V AC OR GREATER.
3-16-90 S19386