Lightwave Communications SCS3230 - Manual (Page 72)

ConsoleServer 3200 System Lightwave Communications
Rev. A - 72 - www.lightwavecom.com
7.10.1 LINESPERPAGE Command
sys admin>>linesperpage
Lines per page set to 22
sys admin>linesperpage 10
Lines per page set to 10
sys admin>>
The
LINESPERPAGE command allows the sys admin to change the number of lines displayed
per terminal page on the control card port before the MORE prompt is displayed. The number of
lines to display per page is entered after the command. Entering the command without a
number following will display the current number of lines displayed per page. The default value
is 22, which will work properly with a 24-line display.
7.10.2 TIMEOUT Command
sys admin>>TIMEOUT
Timeout set to 1 minutes
sys admin>>TIMEOUT 0
Timeout set to 0 minutes
0 disables the timeout from occurring
sys admin>>TIMEOUT 5
Timeout set to 5 minutes
sys admin>>
The
TIMEOUT command allows the sys admin to define a time limit on how long an idle sys
admin terminal may remain logged in. If there is no interaction for the defined amount of time,
the control card will log out the sys admin. The time limit in minutes is entered as a command
qualifier after the command, and must be entered as a whole number. Defining the time limit as
0 will disable this function. The default value is one minute.
7.11 Breaking User Connections
The sys admin has four commands available to forcibly break user connections to
devices. The commands
BREAK and FORCELOGOUT allow the sys admin to break any
connection on demand, while TELNETTIMEOUT and MODEMTIMEOUT automatically
break idle user sessions for the network or modem card.