Land Pride ZXT60 - Manual (Page 20)

18
Section 2: Operating Procedures
ZXT54 & ZXT60 Pro Zero Turn Mowers 357-271M 7/30/12
Table of Contents
Moving Mower with Stalled Engine
Refer to Figure 2-8:
Located under the seat and in line with the rear wheels
are two hydro-drives. One on the right side and one on
the left side. Each hydro-drive is equipped with a bypass
valve for moving the mower manually when the engine is
inoperable. The bypass valve is located on the back side
of the pumps just left of the suction line and is identified as
a hex brass stud. Before moving mower manually:
1. Loosen bypass valves with a 9/16" wrench. Turn hex
brass stud counter clockwise two full turns.
2. Position both control levers in neutral with handles
fully apart.
3. Release park brake lever.
4. Mower rear wheels should now turn freely.
.
Bypass Valve (Right Side Shown)
Figure 2-8
Safe Operating Instructions
The safe operation of any machinery is a big concern to
all consumers. Your Zero Turn Mower has been designed
with many built-in safety features. However, no one
should operate this mower before carefully reading this
Operator’s Manual and all instructions noted on the
safety decals.
!
DANGER
Prior to operating the mower , the operator should be
thoroughly familiar with the proper use and operation of the
equipment, should read the manual completely and
thoroughly, and should have attempted slow moving
maneuvers to become familiar with the operation of the
equipment before attempting normal speed operation. An
inexperienced operator should not mow on slopes or on
uneven terrain.
IMPORTANT: Do not tow the machine. Move it by
hand or use a winch and load it on a trailer.
IMPORTANT: After making necessary repairs and
before operating the mower, retighten the two
bypass valves to 84-104 in-lbs. of torque.
25948
Bypass Valve
(9/16" Wrench)
Hydro-Drive
Suction Line
!
DANGER
Never place hands or feet under the deck or attempt to make
any adjustments to the mower deck while the engine is running
or when the blades are engaged. Mower blades rotating at a
high speed cannot be seen and are located very close to the
deck housing. Fingers and toes can be cut off instantly.
!
DANGER
Always use seat belt with Roll Over protection System (ROPS).
The ROPS can offers protection to the operator in a rollover
situation only if that person is contained within the ROPS
perimeter. Not using the seat belt in a rollover can throw the
operator from the mower causing serious injury or death.
!
DANGER
Do not mow with people present in the mowing area.
Projectiles can suddenly without warning discharge from
under the mower deck causing serious injury or death.
!
DANGER
Never direct discharge of material from mower deck towards
people, animals or buildings. Keep discharge chute in its
lowest position and never remove discharge chute unless a
complete grass collection system is in place. Projectiles can
suddenly without warning discharge from under the mower
deck causing serious injury or death.
!
WARNING
The tailpipe and muffler are very hot and can ignite dry
grasses, brush and other flammable materials. Always keep
area around the muffler and tailpipe clear of debris. Allow the
muffler and tail pipe to cool completely before removing any
debris to prevent sever burns to the body. Make sure all debris
around the muffler have been removed before parking the
mower inside a building or garage.
!
WARNING
Mower deck and operator platform can be slippery when wet.
Always make sure your footing is secure when climbing onto
the mower to be seated.
!
WARNING
Always wear hearing protection, safety glasses, clothing that
does not hang loosely, and shoes or boots when operating this
machine. All shirts should be buttoned up the front and tucked
in the trousers, long sleeve shirts should be buttoned at the
cuffs. Some conditions may warrant extra safety gear be worn
such as dust masks and safety helmets.
!
CAUTION
Always check area to be mowed for rocks and other debris
before mowing.