Land Pride ZXT60 - Manual (Page 56)

54
Section 8: Troubleshooting
ZXT54 & ZXT60 Pro Zero Turn Mowers 357-271M 7/30/12
Table of Contents
Section 8: Troubleshooting
Symptoms Probable Causes Suggested Remedies
Starting motor does not crank Control levers are not in neutral position Place control handles in neutral (OUT)
Park brake not engaged (ON) Engage park brake
Blade Engagement switch is engaged Disengage blade switch
Weak or dead battery Recharge or replace
Loose or broken switches
and/or damaged electrical wiring. Repair or replace switches and electrical
wiring
For additional causes See engine manual
Engine cranks but does not start No fuel in the fuel tanks Fill tank
Fuel filter and/or fuel line plugged Replace fuel filter and/or fuel line
Fuel tank valve turned to “OFF” Select a fuel tank with gasoline
See Figure 5-13 on page 39.
Fuel tank valve turned to an empty tank Switch fuel valve to the other tank
See Figure 5-13 on page 39.
Numerous See engine manual
Engine:
Runs with continuous misfiring or
engine runs unevenly or erratically Numerous See engine manual
Grass cutting is ragged or uneven Dull, bent or broken cutting blades Sharpen or replace cutting blades
Deck full of wet sticky grass Clean underside of deck
Cutting Blades are not operating at full
engine speed Increase engine rpms to full speed (3600 rpm)
Check engine speed with Land Pride Inductive
Tachometer, Part No. 890-909C
Belt over center take-up is loose Tension over center take-up
Worn or broken belt Replace worn and broken belt
See “Belt Maintenance” on page 42
Deck is not level Check air pressure in all 4 tires
Make level adjustments to the deck
See “Deck Leveling Adjustments” on page 26
Loss of power or system will not
operate in either direction Bypass valve open Close bypass valve
See Figure 2-8 on page 18
Linkage bolt is loose or lost Replace linkage bolt
Bad ground drive belt and/or pump idler
pulley Replace belt and/or idler pulley Tighten idler
pulley if loose
Loose, lost or broke idler pulley spring Reattach or replace idler pulley spring
Restrictions in air cleaner Service air cleaner
Internal interference or leakage in Hydro-
Drive See your dealer
Insufficient hydraulic oil supply Check hydraulic oil level in expansion tank and
add oil if needed
Poor compression See your dealer
Steering linkage needs adjustment Adjust linkage See “Steering Adjustments” on
page 22
Air in system Check filter & fittings
For additional causes See engine manual