Little Wonder 6232 - Manual (Page 8)

1. Remove the air filter cover from the engine.
2. Use a 10mm socket to loosen the throttle lever
pivot nut.
3. Move the remote throttle lever so that the center
of the lever is lined up with the turtle’s tail.
4. Move the engine throttle lever to the slow posi-
tion (push throttle lever to the front of the edger).
5. Remove the throttle cable retaining clamp and
screw from the engine.
THROTTLE INSTALLATION
INSTRUCTIONS
6. Insert the end of the throttle cable into the hole on
the engine throttle lever.
7. Place the cable-retaining clamp over the cable,
insert the screw and tighten.
8. Replace the air filter cover.
9. The remote throttle lever should move from slow
to fast and be approximately centered in its slot.
10. If the throttle feels tight, loosen the engine throttle
lever pivot nut.
11. If the throttle does not stay where it is placed,
tighten the remote throttle lever pivot nut (key # 63).
Fig. 4
W
ARNING
- A
LL
L
ITTLE
W
ONDER
E
DGERS
A
RE
S
HIPPED
W
ITHOUT
O
IL
. W
HEN
F
ILLING
O
IL
-
Use SAE 30 Oil. R
EFER
T
O
E
NGINE
M
ANUFACTURES
I
NSTRUCTION
M
ANUAL
F
OR
P
ROPER
E
NGINE
O
PERATION
I
NSTRUCTIONS
8