Light & Motion TITAN D100 - Manual (Page 10)

L R
OFF
+
(Fig. 40)
L R
OFF
+
(Fig. 41)
L R
OFF
+
(Fig. 42)
FOCUS
+
SUB
+
SUB
(Fig. 43)
FOCUS
+
SUB
+
SUB
(Fig. 44) (Fig. 45)
FOCUS
+
SUB
+
SUB
(Fig. 46)
FOCUS
+
SUB
+
SUB
(Fig. 47)
Press and hold to
deactiveate strobe(s).
Press and hold both buttons
to enter “AEL-AFL” mode.
LED will blink four times when
switching to AEL-AFL mode.
Press these buttons to
increase or decrease strobe power.
Press strobe select button to adjust
strobes together or independently.
To change focus zones: First
Press and hold the Focus button.
Then press the “Sub -”
button to change focus zones.
Using ROC for area focus select
This feature requires the Focus button to be set up in the AE-L / AF-L function outlined
in the previous section.
1. Press and hold the Focus button (Fig. 46).
2. While holding the Focus button press the Sub - button (Fig. 47).
You will see the focus area highlighted in the view finder.
3. Continue holding the Focus button and pressing the Sub - button to scroll through the
focus zones of the camera.
Changing D100 Lenses
The Titan D100 has a lens release mechanism that allows you to change camera lenses
with the camera inside the Titan housing.
1. Remove the Titan port.
2. Press the lens release lever that extends to the camera’s lens release button.
3. Continue holding the lever and turn the lens clockwise to remove it.
Attaching Light & Motion Ports / Conversion Rings
To Install Lens / Conversion Ring
1. Inspect O-rings for serviceability.
2. Align bayonet details on lens/ring to bayonet details on housing.
3. Press lens/ring into housing and ensure the entire mating surfaces are flush (Fig. 49).
4. Rotate clockwise until locking pin engages (Fig. 50).
To Remove Lens / Conversion Ring
1. Slide locking pin away from lens/ring (Fig 48).
2. Rotate lens/ring counter clockwise until port/ring stops.
3. Pull away from housing.
Attaching Light & Motion Lens gears
Refer to the instructions that were packaged with your gear set for gear instalation.
Light & Motion ports and gears are made for Nikon Lenses. The following lenses are
suported; 14mm, 16mm, 18mm, 20mm, 24mm, 17-35mm, 60mm, 105mm and 12-24 DX.