Light & Motion TITAN D100 - Manual (Page 6)

Front Controls
Shutter Lever: Accesses the camera’s shutter button (Fig. 27).
The Shutter Lever also activates the camera’s auto focus when depressed
half way.When depressed fully, the camera will take a photo.
Focus Mode Selector (Fig. 28): Selects camera’s focus mode.
Left Smart Grip (Fig. 29)
Main + button: Increases shutter speed in M and S shooting modes.
Main - button: Decreases shutter speed in M and S shooting modes.
The Main + / - buttons perform all main command dial functions.
L ~ R OFF: Selects strobe control mode and deactivates strobes.
Strobe power can be controlled independently from the respective side handle or
strobe power can be controlled together from either handle.
To control strobes independently, press the button until the ROC LEDs blink separately.
Strobe power level is controlled by the handle on the same side.
To adjust strobe power together, press the button until both LEDs blink together. Either
handle then controls power level for both strobes.
To deactivate strobes, press and hold button until Strobe OFF LEDs illuminate.
To reactivate strobes, press and release button.
~ + and ~ - buttons: Left strobe increase or decrease power buttons.
Right Smart Grip (Fig. 30)
Sub + button: Increases f/stop in M and A shooting modes.
Sub - button: decreases f/stop in M and A shooting modes.
The Sub + / - buttons perform all sub command dial functions.
~ + and ~ - buttons: Right strobe increase or decrease power buttons.
Focus button: Pressing this button is just like pressing the shutter button half way.
Activates electronic auto focus (half shutter).
Press and hold the Focus button to keep the camera’s focus locked.
While holding the Focus button down, pull the shutter release to take a photo.
Focus button will not function if the Battery Board is not installed.
Also see page 18 to use the AEL/AFL feature of this button.
(Fig. 17) (Fig. 18)
(Fig. 19) (Fig. 20)
(Fig. 21) (Fig. 22)
(Fig. 23) (Fig. 24)