Lacava 1586 - Manual (Page 5)

LACAVA LLC
®
Page 5 of 9
Installation Instructions
1. Remove the locking nut and
rubber washer from the
mounting post.
2. Unscrew the handle from the
vertical pop-up control rod and
then slide the rod through the
slot on the back of the mixer
body. Then screw the handle
back into place.
3. Place mixer body with its
escutcheon ring and o-ring still
attached through the faucet
hole of the mounting surface.
4. From below the mounting
surface, slide the rubber pad
and metal mounting support
onto the mounting post so that it
presses up against the mounting
surface.
5. Screw the locking nut onto the
mounting post by hand until
tight, and then turn an additional
¼ turn using a wrench. Be
careful not to over tighten the
bolt, as this may cause damage
to the mounting surface.