Lacava 1586 User Manual
Page 6
Advertising
LACAVA LLC
®
Page 6 of 9
6. Attach the vertical pop-up
control rod to the connector by
sliding it through its designated
hole and tightening the screw to
keep it in place.
7. Remove the gray plastic cap
from the drain body and then
place the horizontal control rod
into the opening so that the
plastic ball and gasket fit inside.
Then slide the plastic cap over
the rod and tighten back into
place.
8. Attach the horizontal control rod
to the appropriate height on the
connector.
9. Attach the supply lines to the
water supply and check for any
leaks.
Advertising