Lenoxx Electronics CR-186 - Manual (Page 9)

TROUBLE SHOOTING
(Helpful Hints)
SHOULD YOUR SET EXHIBIT A PROBLEM, CHECK THE FOLLOWING BEFORE SEEKING
SERVICE.
SYMPTOM CAUSE
SOLUTION
Alarm does not
come on in the
morning.
AM or PM not set correctly. Is
alarm time set in AM range (PM
Lamp off)?
Advance the clock 12 hours.
FUNCTION switch is in OFF
position. Is the AUTO Lamp off?
Set the FUNCTION switch to
AUTO or ALARM position.
FM is distorted and
weak.
Noise or weak
sound on AM
broadcasts.
No sound.
The clock is
flashing.
Erratic or slow
tape speed
FM antenna wire is not extended.
Station not tuned in properly.
Weak broadcast station.
Signal is blocked.
External interference.
FUNCTION switch is in the OFF
position.
VOLUME control set to minimum
position.
The clock is not set.
A power failure has occurred.
The set’s AC cord is not
connected.
Extend FM antenna wire.
Rotate the set to receive better
signal.
Turn to a stronger Station.
Tune to desired station
carefully.
Turn the radio for better AM
reception or bring set near a
window.
Slide the FUNCTION switch to
ON position.
Rotate VOLUME control for
desired sound.
Set the clock and alarm time.
Reset the clock alarm time and
time of the day.
LENOXX reserves the right to make design and specification changes for product improvement.
Connect set’s AC cord and
make sure outlet has power.
Cassette PLAY
button pops up
Tape sound
distorted
Tape has reached its end.
Tape head, capstan and pinch
roller dirty.
Clock is dead.
Tape old or worn.
Reverse the tape, re-insert and
press PLAY.
Use a different tape.
Clean tape head, capstan and
pinch roller.
CR-186_032200 NLv.2 E 8