LG TL-AT130M - Manual (Page 58)

MAINTENANCE/INSPECTION PROCEDURE
4-21
5-2) Greasing
(1) Greasing guidelines
Apply grease, with a cleaning patch. Do not use exces-
sive grease. It may come into contact with the tape
transport or drive system. Wipe excessive grease and
clean with cleaning patch wetted in Isopropyl Alcohol.
(2) Periodic greasing
Grease specified locations every 5,000 hours.
NOTE:Greasing Points
3
5
7
6
1
7
2
4
1) Loading Path Inside & Top side
2) Base Assembly P2, P3 stopper
3) Shaft
4) L/D Motor Gear Wheel Part 5) Arm Take-up Rubbing Sections
6)Reel S,T shaft(G381:Yellow)
7) Arm Assembly F/L Rotating
Sections
Guide Rail
Base Loading Gear Drive
Gear Sector Gear Cam
Gear Part
Chassis (Left Side) Chassis (Right Side)
5
7
8
1
2
6
4
3
Slider Guide
Slider Guide
1) Loading Path Inside & Top side
2) Base Assembly P2,P3 stopper
3) Shaft
4) Shaft
5) Clutch Assembly D35 Shaft 6) Plate Slider Guide Sections
7) Plate Slider Guide Sections
8) Gear Assembly P2, P2 Rubbing
Sections
Chassis (Top)
Chassis (Bottom)
Gear Rack F/L
Plate Slider