Lenoxx Electronics 820M - Manual (Page 3)

IB-820M(B)-WM-E-050703
TAPE PLAY
1. Check whether or not the tape is tight before it is inserted.
2. Open the CASSETTE DOOR by hand, face the side to be
played toward you, and insert the cassette tape. Close the
CASSETTE DOOR.
3. Connect the headphones to the jack and adjust the headphone
band for proper fit.
4. Press the PLAY button.
5. Adjust the VOLUME to control the sound level you like.
6. To skip portions of the cassette tape, press the FAST
FORWARD button.
7. To stop playing the cassette tape, press the STOP button, and
the power source is also turned off.
(This set has a built-in auto-stop and the tape mechanism will
stop playing and shut off when it reaches the end of the tape.)
8. To hear the other side of tape, flip it over and press PLAY.
TO HEAR THE SAME SONG AGAIN
1. Remove the tape, flip it around to the other side and insert it.
2. Press the FAST FORWARD button for a short time.
3. Remove tape, flip it around to the original side, reinsert and
press PLAY.
--- 3 ---
•
To keep the tape from tangling, firmly
wind the tape before inserting it into the
player.
•
Use of a cassette with more than 90
minutes, such as C-120 (120
minutes), is not recommended. The
extreme thinness of this tape may
damage this set.
CLEANING TAPE HEAD
If the sound drops out or excessive
noise occurs, clean the magnetic head,
capstan and pinch roller with a cotton
swab moistened with alcohol.
BASS BOOST SWITCH
This switch enhances the low frequency (bass) sound at low
listening levels. To suit your taste, switch the BASS BOOST
switch to the right side, the red indicator appears inside the circle.
20M(CR)-WM-E-050703.p65 5/9/03, 12:01 AM 3