Land Pride RTR1042 - Manual (Page 22)

20 RTR10 & RTR15 Series Rotary Tillers 311-431M 11/01/11
Section 3: Adjustments
Table of Contents
Section 3: Adjustments
RTR15 Tiller Hitch Sideshift
Refer to Figure 3-2:
The three point and gearbox can be sideshifted to the left
of tiller center for various working conditions.
!
CAUTION
After sideshifting check to see that the PTO shaft clears all
shields on the tiller, tractor, and the tiller hitch. If not,
decrease sideshift until clearance is obtained.
1. Loosen the two u-bolts (#1) which hold the top
hitch and gearbox frame (#3) to the front tube.
2. Remove the two bolts (#2) which hold the top
hitch and gearbox frame (#3) to the rear of the tiller.
3. Loosen the two u-bolts (#4) which hold the two lower
hitch clevises (#5) to the front tube.
4. Slide the top hitch and gearbox assembly (#3) to the
desired location.
5. Re-center the lower hitch clevises (#5) with respect
to the gearbox.
6. Retighten all bolts and nuts referring to the Torque
Values Chart in the “Appendix” section on page 33.
NOTE: For maximum sideshift, position lower left
hitch clevis outside the side plate.
RTR15 Tiller Hitch Sideshift
Figure 3-2
22255
RTR10 Tiller Hitch Offset
Refer to Figure 3-1:
By shifting the lower hitch clevises (#1) to the side, a
limited amount of offset can be obtained.
1. Loosen the two u-bolts (#1) which hold the two lower
hitch clevises (#2) to the front tube.
2. Slide the two lower hitch clevises (#2) an equal
amount to the desired location.
3. Retighten all bolts and nuts to the correct torque
value.
!
CAUTION
After offsetting, check to see that the driveline clears all
shields on the tiller, tractor, and tiller hitch. If not, decrease
offset until clearance is obtained.
RTR10 Tiller Hitch Offset
Figure 3-1
22249