Lantronix Data Center-Grade Evolution Device Server EDS32PR - Manual (Page 149)

C: Networking and Security
EDS Device Servers User Guide 149
(Since the remote port was not specified in the ATDT command, the remote port
defined under Connect mode is used.)
‹ Entering ATDT 28.150 causes the EDS to assume the first two octets in the IP
address and connects to the remote IP address 192.168.28.150, port 10001.
‹ Entering ATDT 150 causes the EDS to assume the first three octets and
connects to the remote IP address 192.168.16.150, port 10001.
‹ Entering ATDT 28.150:10012 causes the EDS to assume the first two octets in
the IP address and connects to the remote IP address 192.168.28.150, port
10012.
Note: If you add 10012 after the IP address segment, port 10012 is used instead
of the port defined in Connect mode.
By default, the +++ characters are not passed through the connection. To pass them
through the connection, enable Echo Pluses on the Tunnel - Modem Emulation page
(see
Tunnel – Modem Emulation Page on page 65).