Lenoxx Electronics PH-318 - Manual (Page 11)

3.Snap Wall Mount Adaptor into bottom of phone as shown on adaptor (“UP”
pointing to top of phone).
4.The longer wire plugs into the back of phone leave the other end out, showing
about 3” of wire. Plug the 3” wire into wall jack.
5.Put phone over wall plate, make sure both posts fit into slots on the back of
phone. Then push down to lock phone onto wall plate.
10
FOR WALL USE PUT ADAPTOR HERE
WALL MOUNTING
FOLLOW THESE INSTRUCTIONS TO MOUNT THE PHONE ON THE
WALL WITHOUT A WALL PLATE
Make sure space
between holes is
Follow these instructions to mount the phone on the
wall without a wall plate:
1. Locate a wall stud. If it is possible to utilize a wall
stud for mounting, dry wall expanders or a similar
type fastener is recommended. Consult your local
hardware stores for details.
2. Drill 2 holes 3 15/16" (100 mm) apart.
3. Put a screw into each hole and leave 3/16” (5mm)
of the head exposed to mount the phone (screws
are not included).
4. Connect the straight cord to the phone and jack.
5. Place the Telephone Base on the 2 mounting screws
and gently push down to lock into place.
Drill one hole
Drill one hole
100 mm
PH-318120499 MS V.3 E