Lincoln Electric WELD-PACK 100 PLUS IM546 - Manual (Page 33)

C-1 ACCESSORIES
WELD-PAK 100
3. Change drive roll orientation (if required)
for the wire size selected. See “Changing
Drive Roll” in Maintenance section for
details.
4. Install the proper gun liner and tip for the
wire size selected. See “Component
Replacement” in Maintenance section for
details.
5. Remove gasless nozzle (if installed) and
install gas nozzle. To remove, simply
unscrew.
6. Load wire into machine and thread into
gun and cable per “Welding Wire
Loading” section.
OPTIONAL ACCESSORIES
1. K520 Utility Cart — Designed to trans-
port the Lincoln family of small welders.
Has provisions for mounting a single gas
cylinder. Has front casters and large rear
wheels.
Handle height is easily
adjustable. Bottom tray provided for tools
and accessories. Easy assembly
required; takes less than 15 minutes.
2. K664-1 Aluminum Feeding Kit — This
kit required for welding with .035
Aluminum wire. This kit may also be
used for feeding .035 stainless wire.
Included with this kit are a drive roll, liner
and contact tip. It is important when
changing between welding with steel
wire and aluminum to exchange these
components due to the lubricant
applied to steel wire. Failure to do so
may result in contaminated welds
when welding aluminum.
3. K610-1 MIG Conversion Kit for the
WELD-PAK 100 — Complete kit for use
with .025" (0.6 mm) electrode wire and
either CO
2
or Argon-mixed gas. Includes
.025-.030" (0.6-0.8 mm) cable liner, two
.025" (0.6 mm) contact tips, gas nozzle,
2 lb. spool of .025" (0.6 mm) L-56 elec-
trode, gas regulator, gas hose, regulator
adapter for CO
2
cylinders and gas sole-
noid assembly, with all necessary hard-
ware and easy instructions for installing
gas solenoid. Use with .030" (0.8 mm)
wire requires additional .030" (0.8 mm)
contact tip and electrode wire.
MIG CONVERSION
Several changes are needed to convert the
unit for operation with the MIG (GMAW)
process. The K610-1 MIG Conversion Kit
for the WELD-PAK 100 includes all the nec-
essary accessories for this conversion and
is provided for this purpose. The following
conversions should be made using the con-
tents of this kit:
1. Install the gas solenoid. Complete
instructions are included with the kit.
2. Change the output polarity to DC(+). See
“Work Cable Installation” in Installation
section for details.