Logitek Standard Elec. Cable Manufacturing MON-10 User Manual
Page 4
SECTION 1 — GENERAL INFORMATION
1-1 General Description
The Logitek MON-10 is a mechanical routing
switcher, a six-range VU meter and a six-watt amplifier
all in one convenient rack-mounted unit.
The MON-10 features ten balanced stereo inputs,
any one of which can be selected using front-panel
pushbuttons. The selected input is passively fed to
balanced output terminals on the rear panel. It is also
buffered and fed to a four-position source mode
switch. This switch selects whether the meter and
monitor will be fed the left channel, the right channel,
the mono sum (L+R) or the out-of-phase difference
(L-R).
The output of the source mode switch feeds a meter
amp, which in turn feeds a built-in VU meter and peak
LED. The VU meter can be switched between any of
six ranges, as determined by the front panel meter
switch. The mode switch also feeds a six-watt monitor
amp, which in turn feeds either a built-in speaker,
headphones, or an external speaker.
1-2 Physical Description
The Logitek MON-10 is constructed within a 3 1/2"
H x 19" W X 7" D cabinet, which is designed to take up
two rack spaces in a standard 19" equipment rack.
The power cord, fuse and all connections except the
headphone jack are located on the rear panel. The
headphone jack, meter, speaker and all controls are
located on the unit’s front panel.
1-3 Electrical Specifications
Number of Inputs:
10 stereo
Input Level:
normal
0 dBu
maximum
+23 dBu
Input Impedance:
140kohms
Line Output Level:
Line output switching is passive so the output
level, impedance and balancing is the same as
that of the selected input.
Speaker Output Level:
maximum
6 watts
Speaker Output Noise:
ref. 0 dBu input
60 dBu
AC Line Input Voltage:
50-60 hz
105-129 V
(optional factory modification for 220-240 VAC)
1-4 Instrument Identification
The MON-10 is identified by a model number and a
three or four digit serial number. The model number
and serial number appear on a label on the back of the
unit near the power cord. All correspondence to your
Logitek dealer or to the Logitek factory should refer to
the model number and serial number.
1-5 Where to find help
Logitek customer service personnel are available
to help with any questions, comments or problems you
might have with the MON-10, both during and after the
warranty period. Our hours of operation are 8AM to
5PM central time. We may be contacted in one of the
following ways:
By Phone: 877-231-5870 (U.S.A. & Canada)
or 713-664-4470
By Fax:
713-664-4479
By Email:
By Mail:
Logitek Electronic Systems, Inc.
5622 Edgemoor Drive
Houston, TX 77081
USA
** MON-10 Instruction Manual **
Page 2