Logitek Standard Elec. Cable Manufacturing MON-10 - Manual (Page 6)

SECTION 3 — OPERATING INSTRUCTIONS
3-1 Input Selector Pushbuttons
The meter, monitor, and output terminals can be fed
from any one of ten different stereo inputs. The input is
selected by depressing any of the ten pushbuttons on
the front panel. Inputs may be labeled using the re-
movable label strip under the pushbuttons.
3-2 SOURCE Switch
The SOURCE switch determines the mode of the
signal fed to the meter and monitor, but DOES NOT af-
fect the line output signal. From the stereo input se-
lected on the input selector pushbuttons, the
SOURCE switch selects the left channel, the right
channel, the mono sum (L+R) or the out-of-phase dif-
ference (L-R) signal to feed to the meter and monitor,
allowing a visual and aural evaluation of channel bal-
ance and source phasing.
3-3 METER Switch
The METER switch determines the 100% VU level
of the meter. By selecting any of the six positions, the
user can measure audio levels over a wide range. The
METER switch DOES NOT affect the line output or the
speaker and headphone level.
3-4 VOLUME Control
This control sets the level fed to the internal
speaker, the external speaker and the headphone
jack. It DOES NOT affect line output signal or the me-
ter.
** MON-10 Instruction Manual ** Page 4