Lyngdorf Audio CD-1 - Manual (Page 8)

- 8 -
itself at the start of the selected track but it remains in pause mode until the play/pause
button is pressed again.
(7) Stop
Pressing stop during play or pause mode will stop the CD.
(8 & 9) Skip / Scan
Pressing briefly on the Left |<< Skip/Scan button or turning the skip wheel left will restart
the current track or, if currently playing within the first two seconds of the current track,
skip to the previous track.
Turning the skip wheel right or pressing shortly on the >>| button will skip to the next track.
Skipping left from the first track will always restart this track while skipping right from the
last track will have no effect - unless the CD-1 is in Repeat All mode. In this case, the CD-
1 will loop-around to the last / first track.
Holding the |<< or >>| buttons down for more than half a second will start the CD
searching (Scan) in the indicated direction. The CD starts at approximately twice the
normal speed, but after a few seconds the speed will increase further.
Searching (Scan) past the end of the disc or before the start of the disc will stop the disc
playing, unless the CD-1 is in Repeat All mode. In this case, the disc will loop-around to
the start or the end of the disc.
(10) Menu functions
In the menu there are several options for setting up the CD-1, press Menu to enter. In the
main menu, the different menu items can be selected with the |<< and >>| keys or with the
skip-wheel. Once the correct menu item has been found, pressing the play/pause button or
the skip-wheel will enter the sub-menu.
In the sub-menus the current value of the setting is shown. A new value can be selected
using the |<< and >>| keys or the skip-wheel. To accept the change, press the play/pause
button or the skip-wheel. Pressing the menu button again or selecting <Exit Menu> will
exit the menu without saving changes.
(11 & 12) Play/Select (also referred to as the Skip Wheel)
The Play/Select button is a skip-wheel which allows you to Skip left |<< and Skip right >>|
by turning the wheel in either direction. The button in the centre works in exactly the same
way as the play/pause button. During play mode, it toggles between play and pause. In
the menu mode the button is used as the select-function.
A-B Repeat mode
A-B Repeat mode is entered by pressing the [A/B] button on the remote once to mark the
start time [A] then pressing it again to mark the end time [B]. Pressing the [A/B] button a
third time will return the CD-1 to normal playing mode.
Using other functions such as skip, scan or direct track selection from the remote control
will also exit to normal playing mode.
If the [A/B] button is pressed during Random mode and/or Repeat One mode, these
modes will be cancelled.