Lindy ATA-133 - Manual (Page 5)

- 5 -
3.7. Resolving Conflict
When a RAID set is created, the metadata written to the disk includes drive
connection information (Primary and Secondary). If, after a disk failure, the
replacement disk was previously part of a RAID set (or used in another system),
it may have conflicting metadata, specifically in reference to the drive
connection information. If so, this will prohibit the RAID set from being
either created or rebuilt, in order for the RAID set to function properly, this
old metadata must be first overwritten with the new metadata. To resolve
this, select Resolve Conflicts, and the correct metadata, including the
correct drive connection information, will be written to the replacement disk.
4. Installing Drivers And Software
Windows 2000 Operating System
After the board has been properly installed, when the computer is powered
on, the OS will automatically search for new devices. When the new board is
found, a window will appear asking Found New Hardware Wizard.
Click Next, and Select search for a suitable driver for my device [recommend]
click next, select specify a location click next, Insert the floppy disk into the
floppy disk drive and click Browse.
Most floppy disk drives are configured as [A:]. Choose the [A:] drive in your
browser and the PnP680r.sys file for the SiI 0680 or PnP649r.sys file for the
SiI 0649 should appear. Select the file and click Open:
Verify that the directly listed in this window is A: and click OK then click next.
Now, a window verifying that the new Driver for the board has been properly
installed. Click Finish.
To install Medley, use Windows InstallShield by performing the following:
1. After computer restarts, insert floppy disk in floppy disk drive.
2. Double-click on My Computer.
3. Double-click on 3 1/2 Floppy [A:].
4. Double-click on Install SiIConfig.exe.
5. Follow on-screen instructions to complete installation. Note: Do NOT install
in the Start Up folder. Choose the Default folder (normally Accessories or
Administrative Tools or something similar).
Windows NT Operating System
Windows NT does not have an automatic “Find Device” setting and so after