Listen Technologies Interpreter Set IS 6132P - Manual (Page 10)

Danish Interpretation Systems User Manual
Manual 01 18 04445 10
If the B-select buttons is pressed the last two menu
items are shown:
A menu is selected by pressing the button to the left
of the menu (a-d). Then the display shows the next
level of menus or selections.
Booth selection
Pressing the (d) button selects the Booth set-up
menu:
Press c-button for selecting the Booth number for
the Interpreter Set. A black dot is indicating the
selection. Then use Relay-select up/down to scroll
through the available languages. The Desk number
will automatically change to the next available desk
for the selected language. To save the selection,
press OK (B-button).
If the desk number is set to an already occupied
desk number the set will take over the configuration
from the set on that desk and the other set will be
loose the configuration.
“B” language selection
When B-language is selected by pressing the c-
button, the following menu will appear.
Press button (c) for selecting the B-language for the
Interpreter Set. A black dot is indicating the
selection. Use Relay-select up/down to scroll
through the available languages.
Press button (a) for selecting the B-mode for the
Interpreter Set. The B-mode selection has the
following choices:
All The interpreter can select any B-language
himself.
One Only the B-language chosen at the B-
language selection can be used during operation.
None During operation no B-language can be
used (the B-button has no function except for b-B).
To save the selection, press OK (B-button).
Ver. and serial no.
This is an information menu showing the version,
software serial number and the address assigned to
the unit by the CU 6010 Central Unit.
Press OK to return to the Set-up menu
Communication status
This is an information menu showing the
communication status of the unit.
Press Reset to reset the number of Errors etc.
counted. After start up, some errors can be seen, but
if the numbers of errors are constantly increasing,
the cabling or a unit is defective. The fault could
also be a LAN connector, which is not properly
inserted. Please note the “click” from the lock,
when inserting the connector.
Press OK to return to the Set-up menu.
If the communication during start up is failing in a
way, that the Interpreter Unit will not work, this
screen will be shown instead of normal welcoming
screen.
-Backlight ▲
-AB with mic on
▼
Booth:
■ 7 - 7 Norwegian OK
Desk number: Cancel
1
B-language:
■ 7 Norwegian OK
B-mode: Cancel
One
IS6132 rev. D
SW ver.: 053.009 OK
Serial #: 055.004.255
Address: 215
Rx Errors: 0
Tx Retries: 0 OK
Tx dropped: 0 Reset