Listen Technologies Interpreter Set IS 6132P - Manual (Page 12)

Danish Interpretation Systems User Manual
Manual 01 18 04445 12
If one of the buttons is held down for more than one
second the channels will scroll through the
languages with a speed of 2-4 languages per
second.
Only the number of channels set at the Channel Set-
up menu at the CU 6010 can be selected and shown.
The numbers will always be in succession from 1
and up. The same is the case for the CS 6032
channel selectors, with the exception, that the CS
6032 is also showing channel 0 (floor)
Showing quality of Incoming language
To the right of the four a-d language abbreviations
of the quality of the source is shown.
If there is no interpretation at the channel (Floor
audio is present) then “FLOOR” will be shown.
When there is an interpreters set switched on to the
channel where the interpreter is listening to Floor,
then a quality indication “+” is shown.
When an interpreter’s set is switched on to the
channel where the interpreter listens to another
channel whose interpreter listens to Floor, a quality
indication “-.” is shown. This is indication one relay
interpreting.
Brought one level further, a quality indication “- -.”
is shown. This is indication for double or more
relay interpreting
When interpreting on the A-language and the A-
language of the Interpreter Set is selected, then
“FLOOR“ will be shown, preventing that the
interpreter hears himself. For testing purpose, the
corresponding a, b, c or d button can be pressed for
3 seconds the listening audio will then switch to the
interpreter himself and the quality indication change
to “SELF”. When releasing the button, the listening
audio will switch back to Floor and the quality
indication changes to “FLOOR” again.
If the A-language is not selected the quality
indication “SELF” is shown
All a-d selections show the actual quality of the
channels at all times.
Selection of Outgoing channel
The two push buttons A and B are used to select
whether the interpreter will be routed to the A- or
B-outgoing channel.
When A is pressed the red LED is lighted in the
button. When B is pressed the light in the A-button
will go out and the red LED in the B-button will
light up.
The A-lines will always show the language of the
one selected for the Interpreter Set. The upper line
at the left shows the channel number and the lower
line shows the languages in full name in accordance
to the language list supported (max. 10 char.).
When the system is initialised and set up then the
A-display will show the booth languages and A is
automatically selected. B-display will show the B-
language selected at the B-language Set-up
When B is pressed the light LED in the button is lit.
It is now possible to change the selection of the B-
language channel with the B-select push buttons up
and down if the B-mode is set to “All” in the B-
language setup menu.
The B-selection will only function when B is
selected and the Microphone is not switched On.
Microphone on/off
When the push button is pressed the microphone
audio is put on to the outgoing channel; the LED’s
in the button and the lamp of the microphone are lit
up. If another interpreter already occupies the
outgoing channel nothing will happen.
When the push button again is pressed the sound
from the microphone, the button LED’s and
microphone lamp is switched off.
Mute
The button will switch off the audio from the
microphone to the outgoing channel while it is
depressed (the channel is muted). Also the light ring
in the microphone is switched off while depressed.
When the button is released the microphone audio
is switched on again and the light ring in the
microphone is switched on.