Linksys DMRW1000 - Manual (Page 43)

Regulatory Information
36 Controller/Wireless-N Touchscreen Remote
Wireless Home Audio
Regulatory Information
Safety Warning Statement
WARNING: This exclamation point
indicates that there is a caution or
warning of potential risk of bodily injury
and/or it is something that could damage your
property or product.
WARNING: Risk of explosion if battery is
replaced by an incorrect type. Dispose of used
batteries according to the manufacturer’s
instructions or local/national disposal and
recycling regulations.
WARNING: Do not use this product near water,
for example, near bath tube, kitchen sink, in a
wet basement or near a swimming pool.
California Lead Warning Statement
WARNING: This product contains lead, known
to the State of California to cause cancer, and
birth defects or other reproductive harm. Wash
hands after handling.
FCC RF Exposure Statement
The Wireless-N Touchscreen Remote complies with FCC
RF radiation exposure limits set forth for an uncontrolled
environment and meets the FCC RF Exposure Guidelines
in Supplement C of OET65. This device has been tested
in typical lap held operations with the back side of
the device contacted directly to the human body. To
maintain compliance with FCC RF exposure compliance
requirements, avoid direct contact to the transmitting
antenna during transmitting. This transmitter must not
be co-located or operating in conjunction with any other
antenna or transmitter.
FCC Part15 Class B Statement
This device has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This device generates, uses, and
can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference
to radio or television reception, which is found by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna •
Increase the separation between the equipment or •
devices
Connect the equipment to an outlet other than the
•
receiver’s
Consult a dealer or an experienced radio/TV technician
•
for assistance
FCC Caution
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate this equipment.
For operation within 5.150-5.250 GHz frequency range, it
is restricted to indoor environment.
This device does not operate within the 5.25-5.35 GHz
and 5.47-5.75 GHz bands. In this case, the DFS and TPC
functions are not required.
IC Class B Statement (Canada)
This class B digital device complies with Industry Canada
ICES-003 and RSS-210 rules.
Operation is subject to the following two conditions:
This device may not cause interference and 1.
This device must accept any interference, including 2.
interference that may cause undesired operation of
the device.
Règlement de la classe B d’Industrie
Canada
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 et RSS-210 d’industrie.
L’opération est sujette aux deux conditions suivantes:
Ceci le dispositif peut ne pas causer l’interférence et 1.
Ceci le dispositif doit accepter n’importe quelle 2.
interférence, y compris l’interférence qui peut causer
fonctionnement peu désiré du dispositif.
Industry Canada Interference Statement
The device for the band 5150-5250 MHz is only for indoor
usage to reduce potential for harmful interference to co-
channel mobile satellite systems;
The maximum antenna gain 5.94dBi permitted (for devices
in the band 5725-5850 MHz) to comply with the e.i.r.p.