Linn Klimax DS - Manual (Page 10)

KLIMAX DS
Important:
It is strongly recommended that the Klimax DS is installed and
configured by an authorised Linn retailer.
Unpacking
The Klimax DS is supplied with the following:
• handset
• 2 x AAA batteries for the handset
• 1 pair of silver interconnect cables
• RS232 lead
• mains lead
• CD-ROM
• warranty pack
• this manual
We recommend that you retain all packaging in case you need to
transport the Klimax DS at a later date.
Positioning
You can position your Klimax DS almost anywhere you find convenient,
but please consider the following points:
• The unit should be placed on a flat, stable and rigid surface.
• Do not position the unit where sunlight can shine (whether directly,
diffused or reflected) on its display as the infra-red (IR) radiation in
sunlight will be picked up by the unit’s IR remote sensor and this can
adversely affect its operation. Similarly, some electrical devices such
as plasma TVs, fluorescent lights and energy saving lamps can emit
IR which can likewise affect the operation.
• For best performance, do not stack the unit with other products.
Ideally, position the unit on a shelf by itself or, if proximity to other
products is unavoidable, positioning side-by-side is preferable to
stacking.
INSTALLATION
• The unit should not be situated above, or otherwise directly adjacent
to sources of heat such as radiators, power amplifiers etc. Nor
should it be enclosed in a cabinet with such devices.
• The unit itself produces very little heat; however it is advisable
to allow a little space to the sides, rear and above the unit
(ideally 10 cm / 4”) for air circulation which will allow this
heat to dissipate.
Cleaning
Disconnect the Klimax DS from the power supply before cleaning.
Remove dust and fingerprints with a soft, dry cloth.
Connecting to the mains supply
The Klimax DS contains an automatic internal mains voltage
switch. This switch operates on all worldwide mains voltages from
100 V to 240 V. The unit can be connected to any worldwide mains
voltage with no adjustment.
This unit must be earthed. Use the earthed moulded mains lead
supplied, or if no mains earth is available, ensure the product’s
EARTH GROUND connector is connected to an earthing terminal.
2