Linksys PPS1UW - Manual (Page 8)

EtherFast ® Wireless-Ready USB PrintServer
10
1. To begin driver installation, click the Start button, and select Run. Type
D:\Driver\Win9xnt\setup.exe (where “D” is the letter of your CD-ROM
drive) in the Open field that appears. Click the OK button.
2. The Welcome screen appears. Read the text that appears, and click the
Next button.
Installing the Wireless-Ready USB PrintServer’s Drivers 3. The next screen that appears, shown in Figure 4-3, will request you to choose
a destination folder. You can either use the default folder by clicking the
Next button or choose an alternate folder by clicking the Browse button and
selecting a folder from the window that pops up. Click the Back button to
take a step backward in the installation, or Cancel to forgo installation.
4. The Bi-Admin Management Utility will now be installed. When it is com-
plete, you will see Figure 4-4. Click the OK button and continue to the next
section, Installing the Wireless-Ready PrintServer’s Drivers.
For more information about Bi-Admin Management, go to Chapter 5: Bi-
Admin: PrintServer Management.
Note: After you have run the Autorun program and installed the Bi-
Admin Management Utility, the Autorun will still run every time you
insert the CD. Do NOT install the Bi-Admin Management Utility
again. Click the EXIT tab to prevent duplicate installation.
Instant EtherFast ® Series
9
Figure 4-3
Figure 4-4
Figure 4-5
Figure 4-6
Note: Make sure you have an IP address for the computer and an IP
address for the PrintServer. If you need to assign an IP address to the
PrintServer, go to Chapter 5: Bi-Admin: PrintServer Management.