Lexicon DC-2 - Manual (Page 59)

51
DC-2 Digital Controller
DTS Effects and Parameters
5
DTS Effects and
Parameters
Parameter Initial Value Range
CENTER MIX 16 0-30
SURROUND MIX +2dB -5 to +5dB
CENTER DLY SAMPLES +0 -127 to +127
MASTER LEVEL +5dB -5dB to +5dB
LFE MIX LEVEL +0.0dB -20.0dB to +0.0dB
SUBWOOFER LVL +00dB OFF, -30dB to +05dB
CUSTOM
DTS Effects are compatible with DTS Digital Surround input signals. These
effects, along with the PCM Effects described in Chapter 3, and the AC-3
Effects described in Chapter 4, are included in the DTS version of the DC-
2. Any DTS-capable software and/or source components should be labeled
with a badge, similar to the one on the DC-2 front panel (AC-3 and DTS
versions).
This Effect mixes DTS Digital 5.1 information for two-channel playback.
These soundtracks can be recorded onto two-channel formats, or played
back through left and right front speakers. The mix is designed to play back
with full surround when decoded through Logic 7. In mixing a film with
very heavy use of the Low Frequency Effects Channel, it may be desirable
to lower LFE MIX LEVEL. DTS 2-Channel
Parameter Initial Value Range
RE-EQUALIZER OFF ON, OFF
BASS ENHANCE OFF ON, OFF
REAR DLY OFFSET +5ms 0-20ms
SIDE LEVEL +00dB OFF, -30dB to +05dB
REAR LEVEL +00dB OFF, -30dB to +05dB
LFE MIX LEVEL -10.0dB -20.0dB to +0.0dB
SUBWOOFER LVL +00dB OFF, -30dB to +05dB
CUSTOM
This Effect enhances playback of DTS music recordings, or DTS film
soundtracks with strong musical content. This effect contains many of the
features found in DTS LOGIC 7, with settings that are more appropriate for
music. DTS Music