LEICA 2 - Manual (Page 21)

21 Getting started with new equipment GPS Equipment User Manual -2.0.0en
You can now switch off the receiver.
Once power is off disconnect all
cables and put all equipment back
into the shipping case.
You might now move to another site
and repeat the procedure outlined in
this chapter. Once your fieldwork is
finished you can proceed by process-
ing the collected data in SKI-Pro in
order to get accurate baseline re-
sults.
During operation of the
GPS System 500 the PC-
Card memory card is
getting warm.
The data is then read by SKI-Pro
and copied to the project related
database.
Repeat the import process for
each sensor which was involved in
the fieldwork of your project.
Processing the data in the SKI-Pro software
In most cases, a short introductory
course to the software will have been
given by the local Leica Geosystems
representative.
To import and process the data
proceed as follows:
• Switch on the computer, start
Windows, start SKI-Pro.
• Import the data
For each sensor you must import
the data into SKI-Pro
Select "Import GPS Raw Data"
from the toolbar. Follow the
instructions that appear on the
screen.
You may wish to create a new
project before storing the data on
the PC.