LG LST-3510A - Manual (Page 13)

INST
ALLA
TION
13
Connections (Continued)
Display Formats Overview
• The HDTV Tuner offers various display formats and multiple video outputs. When the HDTV Tuner is connected
to A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 480p, and 480i.
• 1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.
• 1080i, 720p, and 480p modes are available for RGB and DVI outputs.
• 480i mode is available for VIDEO, S-VIDEO, and COMPONENT VIDEO outputs.
• The HDTV Tuner has two digital audio outputs; Dolby Digital 5.1 and PCM. The HDTV Tuner sends out a digital
audio signal to OPTICAL and COAXIAL audio outputs when digital broadcasts are being received by the HDTV
Tuner.
Analog Monitor Connections
11 Connect the “Antenna/Cable” to the “ANT IN” jack on the DVD/HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an optional attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 12.)
2 2 Connect the “ANT LOOP OUT” jack on the DVD/HDTV Receiver to the “Antenna In” jack on your TV using a
coaxial RF cable.
3 3 Connect the “AUDIO OUT” and “VIDEO OUT” jacks on the DVD/HDTV Receiver to the “A/V IN” jacks on your
TV using RCA-type cables. If your TV is equipped with an S-Video jack, use the S-VIDEO OUT jack.
Cable TV
Wall Jack Panel
OR
OR
L R
AUDIO INPUT VIDEO
INPUT
S-VIDEO
INPUT
ANTENNA
INPUT
TV Connection Panel
DVD/HDTV Receiver Connection Panel
Antenna