LG LST-3510A User Manual
Page 14
14
Connections (Continued)
HD Monitor Component (YPbPr) Connections
11
Connect the “Antenna/Cable” to the “ANT IN” jack on the DVD/HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an optional attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 12.)
2
2
Connect the “ANT LOOP OUT” jack on the DVD/HDTV Receiver to the “Antenna In” jack on your TV using a
coaxial RF cable.
3
3
Connect the “COMPONENT OUT” jacks on the DVD/HDTV Receiver to the “COMPONENT IN” jacks of your TV
using RCA-type cables. (The Output Selection must be set to YPbPr, refer to Setting the Display Format on
page 19)
4
4
Connect the L/R “AUDIO OUT” jacks on the DVD/HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
ote
The component out jacks are useable if 1080i, 720p, 480p, 480i, native, variable 1, variable 2, or variable 3 display
format is selected.
Y
Pb
Pr
COMPONENT VIDEO INPUT
L
R
AUDIO INPUT
VIDEO
INPUT
ANTENNA
INPUT
Cable TV
Wall Jack Panel
OR
HD Ready TV Connection Panel
DVD/HDTV Receiver Connection Panel
Antenna