Land Pride FD2548 User Manual
Page 11
1/29/04
10
At the end of the working season or when the mower will
not be used for a long period, it is good practice to clean
off any dirt or grease that may have accumulated.
Check the blades for wear and replace if necessary.
See "Maintenance" on page 9.
Inspect the mower for loose, damaged or worn parts
and adjust or replace if needed.
Lubricate as noted in "Lubrication" on page 9.
Repaint parts where paint is worn or scratched to pre-
vent rust.
Remove mower drive belt from one pulley to release
drive belt tension.
Remove belt guards, thoroughly clean the top and bot-
tom of the mower frame.
Store mower in a clean, dry place.
Assemble item numbers 1 through 4 as shown in the il-
lustration below. Position left hand and right hand
mount brackets on mower frame making sure the roller
is running parallel with bottom of the mower deck to 1"
below. Mark the four center points of mounting holes in
brackets. Remove assembly and drill holes 13/32" di-
ameter. Mount assembly to frame making sure that the
pan head screws are installed as shown on illustration
(head side of screw to the inside of mower deck).
STORAGE
OPTIONS
FRONT ANTI-SCALPING ROLLER
ASSEMBLY INSTRUCTIONS
10818