Linn 110 - Manual (Page 4)

Note:
The acoustic array on the KOMPONENT 106 centre channel has been factory
configured for horizontal dispersion. It can however be converted, by your
Authorised Linn Retailer, to allow the loudspeaker to be positioned vertically.
Vertical positioning without conversion is not recommended.
KOMPONENT 106 horizontal alignment –
factory configuration
KOMPONENT 106 vertical alignment –
requires conversion
5.1 system suggested speaker positioning
1
Installation
Positioning
The KOMPONENT loudspeakers have been designed to provide a very flexible
loudspeaker solution. Stand-mounting, wall-mounting and (in the case of the
106 and 104 models) shelf-mounting provide setup options to suit any
application or room layout. An example of such a layout (for a 5.1 system) is
shown below. Ideally, the distance between the front left and right loudspeakers
should equal the distance to the listening position, as indicated.
Whichever mounting method you employ, for best results ensure that the
loudspeakers are held rigidly or positioned stably. This will ensure that as much
of the movement of the drive units as possible is converted to sound energy,
rather than cabinet movement (in the form of vibration, wobble etc.).
The KOMPONENT loudspeakers generally perform best with very little toe-in
(i.e. only very slight angling of the loudspeakers towards the listening position
is required). Some experimentation with the positioning and angle of your
loudspeakers may help to optimise the sound within your room setting.
KOMPONENT 110, 106, 104
ADVANCED FEATURES
Installation English
KOMPONENT 106
KOMPONENT 120
KOMPONENT 110
KOMPONENT 106