Land Pride AFM4014 - Manual (Page 45)

43
Section 7: Features & Benefits
7/28/06 AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers 315-160M
Land Pride
Table of Contents
AFM4016 All-Flex Grooming Mower
Features Benefits
Low pivot points on deck The lower the pivot points are to the ground, the more side to side swing, allowing for
excellent flotation from each deck.
Narrow 6’8” transport width Not much wider than most tractors, making for safer transport. Meets most city/county
codes for transport width.
Gearbox HP Rating 40 - 70 HP
8” Deck overlap Eliminates skipping when going into a tight turn.
Automatic wing locks When wings are raised in the full transport position, the wings lock in place, no need to get
off the tractor to lock.
1/4” Gauge wheel arms 1/4” Sidewall thickness on gauge wheel arms means a great deal of ‘hidden’ strength.
Sleek frame design Single beam hitch design allows for a zero turning radius.
Rear discharge Even dispersal, discharged items are always aimed downward. No rear chains are
needed, which tend to clump damp grass.
Blade rotation Counter rotation; Wing decks throw grass away from the path of the rear deck. Rear deck
doesn’t get covered up nor does it get bogged down by cut grass.
18” Deck tires with sealant 18” Tires offer great flotation, less lbs. per square inch. Sealant minimizes flats.
23” Transport tires with
tapered bearings
23” Transport tires offer smooth roading. Tapered bearings offer longevity.
18,340 fpm Blade tip speed High blade tip speed for clean cut and efficient discharge.
Cat. 4 CV main driveline Constant velocity main driveline allows for tighter turns without harming U-joints in
driveline.
Mulching blades Mulching blades are available.
Cat. 2 slip-clutch wing
drivelines
Reduces start-up torque that is put on the driveline, gearbox and gearbox support.
Easy belt tension release Easily release belt tension for changing belt or for winter storage.
Easy to grease blade spindles No guards to remove for routine greasing of blade spindles.
Gearbox Warranty S/N 368188- one year on all gearbox components.
S/N 368188+ 5 years on gearbox housing, gears and shafts,
3 years on bearings and seals in gearbox.