Land Pride AFM4014 - Manual (Page 31)

29
Section 5: Maintenance and Lubrication
7/28/06 AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers 315-160M
Land Pride
Table of Contents
Step 1
Remove snap ring.
Step 2
Remove backup ring, lock collar,
compression spring, bottom backup
ring, and balls.
Step 3
Tighten the four hex nuts uniformly until
the clutch pack and hub are loose.
Step 4
Bend all four retaining lugs out on the
edge of the clutch housing.
Step 5
Remove the thrust plate with the
Belleville Springs and lug rings to
access friction disks and hub for
inspection or service.
Step 6
Inspect friction disks and hub.
Step 2
Compress the Belleville Springs to the
pressure plate by tightening the four
hex nuts and then placing the assembly
into the clutch housing.
Step 3
Bend the retaining lugs inward over the
Belleville Spring edges to secure the
spring before backing the four hex nuts
off.
Step 4
With the lugs bent in, loosen the four
hex nuts completely to the end of the
threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring,
compression spring, lock collar, and top
backup ring.
Step 7
Install snap ring.
Step 1
Place the hub and friction disks into the
housing.
Disassembly
Assembly
10435 10449
Clutches With 4-Tightening Nuts
NOTE: Before proceeding, secure the clutch firmly in
a vise or other clamping device to prevent injury.