LevelOne GSW-2401TX - Manual (Page 19)

13
VLAN
Entry:
Select “2” from Main Menu.
Purpose:
Each port of the switch can be assigned to one or multiple VLANs(this
device can be divided into 24 VLANs maximum). Frames from the
source port will only be forwarded to destination ports within the same
VLAN domain. A broadcast/multicast frame will be forwarded to all
ports within the VLAN(s) of the source port except the source port
itself.
An unicast frame will be forwarded to the destination port only if the
destination port is in the same VLAN as the source port. If the
destination port belongs to the another VLAN, the frame will be
discarded .Each port should be assigned with a dedicated uplink port.
Unicast frames with unknown destination addresses will be forwarded
to the uplink port of the source port. An uplink port can either be a
single port or a trunk.
Default:
All ports assigned to one VLAN.
Examples: Suppose the switch with 24 port , assigned port 1,2 to
VLAN group 1 ,port 5,6 belong to VLAN group 2 ,others be assigned to
VLAN group3 ,please follow below steps :
1. type ‘S’ or ‘s’ than input ‘1’ , press ENTER
Select :>> 2
VLAN
VLAN Group 1 ,assigned ports>>
[S] Port Select
[D] Port Delete
[A] Select All Ports
[C] Save
[E] Exit
Select :>>