Lexmark 5300 - Manual (Page 125)

Troubleshooting
Setup troubleshooting
Incorrect language appears on the display
These are possible solutions. Try one of the following:
C
HANGE THE LANGUAGE SELECTION DURING INITIAL SETUP
After you select a language, Language appears again on the display. To change the selection:
1 Press or repeatedly until the language you want appears on the display.
2 Press to save.
S
ELECT A DIFFERENT LANGUAGE AFTER INITIAL SETUP
1 From the control panel, press Copy Mode.
2 Press .
3 Press or repeatedly until Tools appears.
4 Press .
5 Press or repeatedly until Device Setup appears.
6 Press .
7 Press or repeatedly until Language appears.
8 Press .
9 Press or repeatedly until the language you want appears on the display.
10 Press to save.
Note: If you cannot understand the language on the display, see “Resetting the printer to factory default settings”
on page 164.
Power button is not lit
These are possible solutions. Try one or more of the following:
P
RESS POWER BUTTON
Make sure the printer is on by pressing .
Troubleshooting
125