Lenoxx Electronics PDV-709 - Manual (Page 24)

IB-PDV709-WM-E-061006
PRECAUTIONS
Safety
•
As the laser beam used in the DVD player
may be harmful to the eyes, do not attempt
to disassemble the cabinet. Refer servicing
to qualified personnel only (it is perfectly
safe if you don’t unscrew and open the
cabinet).
•
Should any solid object or liquid fall into
the player, unplug the player, and have it
checked by qualified personnel before
operating it any further.
Placement of Your DVD Player
•
Do not leave the player in a location near a
heat source, or in a place subject to direct
sunlight, excessive dust or mechanical
shock.
•
Do not place the player on an incline or
unstable place, it may fall and break.
•
Do not place anything within 2 inches of
the sides or back of the cabinet. The
ventilation holes must not be covered for
the player to operate properly and to prolong
the life of its components.
•
Don’t place this DVD player on lacquer
finished furniture without a cloth, wood or
glass protector in between.
•
Exposure to extreme hot or cold temperatures
may cause damage to the player or cause
it to malfunction. Do not expose the player
to direct sunlight continuously or leave it in
a vehicle with the doors and windows
closed. The case may become deformed
or discolored or the player may malfunction.
Cleaning the Cabinet
•
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a very
mild detergent solution or a plain damp
cloth. Do not use any type of abrasive pad,
scouring powder, or solvent, such as
alcohol or benzine.
•
Never touch the lens with your fingers, if
the lens gets dirty, it will not play. Clean the
disc before use.
Operation
•
If moving from a cold environment to a warm
environment, let the player’s temperature
stabilize before operation. Moisture may
condense on the lens inside. Remove the
disc and wait about an hour for the moisture
to evaporate.
•
If the player has not been used for a long
time, turn the set to ON to warm it up for a
few minutes before inserting a disc.
Cleaning Discs
•
Before playing, make sure the disc is
clean. If not, clean the disc with a cleaning
cloth. Wipe the disc in a straight motion
from the center out.
•
Do not use solvents such as benzine,
thinner, commercially available cleaners or
anti-static spray intended for vinyl LPs.
•
If the disc is scratched, it will not play.
Sometimes a scratched disc can be
repaired with a disc polishing machine
available in many stores.
•
Do not touch the playback side of the disc.
Every fingerprint can cause playback
problems. Do not scratch the disk.
•
Do not store the Discs in a place subject
to direct sunlight or near heat sources.
Handling Discs
23
IB-PDV709-WM-E-061006.pmd 8/3/2006, 11:00 AM 24