Troubleshooting & repair, Caution – Lincoln Electric INVERTEC POWER WAVE 450 SVM112-B User Manual

Page 237

Advertising

F-177

PRINTED CIRCUIT BOARD REMOVAL AND REPLACEMENT

(CONTROL BOARD, POWER BOARD, AND PROTECTION BOARD)

(continued)

TROUBLESHOOTING & REPAIR

Be sure to follow the recommended static-free
methods for handling printed circuit boards.
Failure to do so can result in permanent dam-
age to the equipment.

8. Remove the molex plugs from the PC board

you are removing.

NOTE: The plugs are numbered in order from
left to right.

9. Depress the two PC board retainer clips

located on the left and right sides of the
board. Lift the board by the clips to remove
it.

10. When reinstalling the PC board, make cer-

tain the tabs at the bottom of the board fit
into the slots on the compartment floor.
When the board is properly seated, the
retainer clips will snap into the locked
position.

11. Install the molex plugs removed earlier.

Be sure to fit the each plug into its respec-
tive receptacle on the board.

12. Perform appropriate calibration procedure

per flowchart in Figure F.67.

13. Install the PC board cover and tighten the

two screws with the 5/16" nut driver.

14. Install the machine case sides and top.

15. Install the handle and the lift bail rubber

gasket.

POWER WAVE 450

Retur

n to Section TOC