Changing the set speed, Resuming the set speed, Low speed automatic cancellation – Lincoln MKT User Manual

Page 128: Driver controls

Advertising
background image

When the driver is overriding ACC, the green

cruise indicator light

is illuminated, and CRUISE OVERRIDE is displayed in the message
center. When the accelerator is released, the ACC function will operate
again and vehicle speed will decrease to the set speed, or a lower speed
if following a slower vehicle.

Changing the set speed

There are three ways to change the
set speed:
• Accelerate or brake to the

desired speed and press and
release the SET + or SET –
control

• Increase or decrease the speed by

holding either the SET + or SET
– control, until the desired set
speed is shown on the message
center. The vehicle speed will gradually change to the selected speed.

• Increase or decrease the speed in increments of 1 mph (2 km/h) by

briefly pressing the SET + or SET – control.

The ACC may apply the brakes to slow the vehicle down to the new set
speed. The set speed will display continuously in the message center
while ACC is active.

Resuming the set speed

Press and release the RESUME
control. This will automatically
return the vehicle to the previously
set speed. The set speed will display
continuously in the message center
while ACC is active.

Note: RESUME should only be used
if the driver is aware of the set
speed and intends to return to it.

Low speed automatic cancellation

ACC is not functional at vehicle speeds below 18 mph (30 km/h). Once the
vehicle speed drops below 18 mph (30 km/h), an audible alarm will sound,
the head’s up display will flash and the automatic braking will be released.

Driver Controls

128

2010 MKT (mkt)
Owners Guide, 1st Printing
USA
(fus)

Advertising