Liebherr WS14300 - Manual (Page 11)

11
O
PERATION
Setting the Temperature
- Figure 8, 9
The temperature of all compartments can be
set separately.
Temperature control for upper and middle
compartment at upper control unit - Figure 8
Figure 8
Temperature control for lower compartment
at lower control unit - Figure 9
Figure 9
To reduce the temperature: Press the  “DOWN“
button;
To increase the temperature: Press the  “UP“
button.
- While you are entering the temperature, the set
temperature will flash on the display.
- You can change the settings in increments of 1°F
(1°C) by briefly pressing the button again. The
electronic controls will switch over automatically
about five seconds after the last time you pressed
the button. The actual temperature displays.
If F0 or F1 appears in the display, the appliance has
a fault. Contact your nearest customer service rep-
resentative.
Ventilation Button
- Figure 10, 11
Should you wish to use the wine cooler to
store wine for long periods of time, activate the
“Ventilation“ button. The light in the button comes
on and the ventilation function is active. Then the
climate which corresponds to that of a wine cellar
is achieved inside the wine cooler. Bottle corks are
prevented from drying out due to an increased level
of humidity.
Ventilation button at upper control unit - Figure 10
Figure 10
Ventilation button at lower control unit - Figure 11
Figure 11
Audible Warning Signal
- Figure 12, 13
The audible warning signal helps to protect your
wines against excessive temperature fluctuations.
- The audible warning signal sounds when the door
is open for longer than about 180 seconds. The
audible warning device is turned off by pressing
the Alarm button.
Alarm button at upper control unit - Figure 12
Figure 12
Alarm button at lower control unit - Figure 13
Figure 13
- The audible warning signal sounds when the inte-
rior gets too warm or too cold. The temperature
display will also flash. The audible warning device
is turned off by pressing the Alarm button. The
temperature display will continue to flash until the
cause of the alarm has been rectified.