Power trunk (if equipped), Driver controls – Lincoln 2011 Town Car User Manual

Page 69

Advertising
background image

Position the floor mat so that the
eyelet is over the pointed end of the
retention post and rotate forward to
lock in. Make sure that the mat does
not interfere with the operation of
the accelerator or the brake pedal.
To remove the floor mat, reverse the
installation procedure.

POWER TRUNK (IF EQUIPPED)

Your vehicle may be equipped with a power trunk controlled by the
interior trunk control, the key fob or the keypad on the door.

If anything obstructs the power trunk while it is closing, the trunk will
automatically reverse to the open position, provided it meets sufficient
resistance. Resistance must be as strong as the force of the closing
trunk, or stronger. The force of the closing trunk increases as the trunk
approaches the latched position. The trunk will close with the next press
of the interior trunk control or key fob button.

WARNING: Make sure all persons are clear of the luggage
compartment area before using the power trunk control.

If the battery is disconnected, discharged, or a new battery is installed,
the power trunk needs to be reset. To reset the power trunk:
• Reconnect the battery with the trunk closed
• Power activate the trunk with the power interior trunk release, the

key fob or the keypad on the door to the full open position, then
power activate the same power source and fully close the trunk. The
power trunk is now reset.

Driver Controls

69

2011 Town Car (tow)
Owners Guide, 1st Printing
USA
(fus)

Advertising