Lenco Marine CS-1004 - Manual (Page 10)

OPERATION
c) RETUNE L, RETUNE S mode
The initial time of automatic TA
search or PI search mode is selected.
When PI information is not caught for
retune time, the radio start to retune
to next same PI station. When same
PI station does not catch 1 cyclic
search, the radio goes to last station
and waits for several minutes until PI
code is received.
- RETUNE L mode:
Selected as 90 seconds.
- RETUNE S mode:
Selected as 30 seconds.
d) MASK DPI or MASK ALL mode
The AF frequency (which has
different PI or NO R.D.S. signal with
high field strength) is masked during
checking PI when the unit searches
AF. The unit doesn’t search this AF
(DIP) for few minutes. In the case
of the AF of NO R.D.S. signal with
high field strength, if the real AF is
wrongly masked as DIP by some
interference, the unit hesitates to
search real Afs. For this reason, the
unit has the user option (MASK DPI)
which doesn’t mask the AF of NO
R.D.S. signal with high field strength.
In MASK DPI mode, the wrong
sound or long mute (according to PI
SOUND or PI MUTE) can be heard
from the AF station which has NO
R.D.S. signal and of which the field
strength is higher than that of the
currently tuning AF (station).
But, these phenomenon are rare
and the user will hardly hear the
wrong sound in whole Europe.
- MASK DPI mode:
Masked only the AF which has
different PI.
- MASK ALL mode:
Masked the AF which has
different PI and NO R.D.S. signal
with high field strength.
e) BEEP 2’ND, BEEP ALL, BEEP OFF
mode
The situation of beep sound is
selected. The 3 mode is selected as
also pressng AUDIO SELECT
button (11) or AUDIO SELECT
button (12).
- BEEP 2’nd mode:
The beep is only generated when
all allowed double key is pressed
long (1 sec).
e.g.
When preset button (14) is
pressed.
When BND/LOU button (13) is
pressed.
When AMS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when
every key is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press BND/LOU button (13) for several
seconds to reinforce the bass output.
Press it for several seconds again to
release this function.
DISPLAY
Press DSP button (15) to operate as
the conversion of each display mode
as follows:
- In case of receiving a RDS station
In radio mode:
-> PS -> CT -> FREQ. -> PTY ->
In CD mode:
-> CD -> CT -> PS -> FREQ. ->
PTY ->
- In case of no receiving CT or PTY
information, the display shows as
“NO CLOCK” or “NO PTY”.
- In case of receiving a non RDS station
In radio mode:
-> “NO CLOCK” -> FREQ. ->
“NO PTY” ->
In CD (MP3) mode:
-> CD (MP3) -> CT -> FREQ. ->
GB-10