Lenco Marine CS-1004 - Manual (Page 11)

OPERATION
“NO PTY” ->
Each displaying time is several
seconds, and come back to 1’st
position after several seconds.
Notes:
- CT = clock time
- FREQ. = frequency
EQUALIZATION
Press PEQ button (19) to turn on
equalization function and to select
desired audio mode. There are five kinds
of mode as below:
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
RESET FUNCTION
RESET
button (24) must be activated
with either a ballpoint pen or thin metal
object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (24), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to
clean the socket on the back of the front
panel.
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MOD button (6) shortly to
select radio mode, the radio mode
appears in the display together with
the memory band and frequency.
• SELECTING THE FREQUENCY
BAND
At radio mode, press BND/LOU
button (13) shortly to select the desired
band.
FLAT CLASSICS POP M ROCK M DSP OFF
The reception band will change in the
following order:
• SELECTING STATION
Press TUNE/SEEK/TRACK
button (17) or TUNE/SEEK/TRACK
button (16) shortly to activate
automatic seek function. Press for
several seconds until “MANUAL”
appeared on the display, the manual
tuning mode is selected. If both
buttons have not pressed for several
seconds, they will return to seek tuning
mode and “AUTO” appeared on the
display.
• AUTOMATIC MEMORY
STORING & PROGRAM SCANNING
- Automatic memory storing
Press AMS button (18) for several
seconds, the radio searches from
the current frequency and checks
the signal strength until one cycle
search is finished. And then 6
strongest stations are stored into the
corresponding preset number
button.
- Program scanning
Press AMS shortly to scan preset
station. When the field strength level
is more than the threshold level of
stop level, the radio is holding at that
preset number for several seconds
with release mute, then searches
again.
• STATION STORING
Press any one of the preset buttons
(14) (1 to 6) to select a station, which
had been stored in the memory. Press
this button for several seconds, (Until
2’nd beeps come out), current station
is stored into the number button.
• R.D.S. (RADIO DATA SYSTEM)
OPERATION
- Setting R.D.S. Mode
Press AF/REG button (3) and release
FM1 FM2 FM3
GB-11