Lennox Hearth Brentwood SP - Manual

EPA Wood-Burning Fireplaces
P/N 850,039M REV. G 11/2008
BRENTWOOD SP
MODEL
BRENTWOOD™
This installation manual will enable you to obtain a safe, efficient and
dependable installation of your fireplace system. Please read and
understand these instructions before beginning your installation.
Do not alter or modify the fireplace or its components under any circum-
stances. Any modification or alteration of the fireplace system, including
but not limited to the fireplace, chimney components and accessories,
may void the warranty, listings and approvals of this system and could
result in an unsafe and potentially dangerous installation.
Lennox Hearth Products wood-burning fireplaces are designed for use
as a supplemental heater. They are not intended for continuous use
as a primary heat source.
INSTALLATION AND
OPERATION INSTRUCTIONS
Listed to standards:
ULC-S610 & UL-127
Report No. 3011202
EPA Cert. No. 537
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
WARNINGS
• Hot! Do not touch! The glass and
surfaces of this appliance will be hot
during operation and will retain heat
for a while after shutting off the appli-
ance. Severe burns may result.
• Carefully supervise children in the
same room as appliance.
• If small children are present in the home, it
is recommended that this appliance be fitted
with a firescreen kit. See Page 21 for ordering
information.
WARNINGS
• The fireplace cannot be operated without a door.
Consult your dealer to select the correct door
model.
• Important! To assure proper alignment of glass
doors: Install this fireplace in a square and
plumb condition, using shims as necessary at
sides and/or bottom.
• Install the fireplace only as described in these
instructions.
PIBRENTW REV. 11 NOV 2008
TM
Fireplace, also for use in mobile or
manufactured homes with solid fuel only.
DR
AF
T
11
/10
/20
08