Land Pride Razor Pro ZRP52 User Manual
Page 11
9
Section 2 Operating
7/14/08
ZRP44 & ZRP52 Zero Turning Radius Mowers 356-117M
Land Pride
Left/Right Fuel Tank Valve
Refer to Figure 2-3:
The mower is equipped with a Left/Right Fuel Tank Valve
located on the right side behind the seat. It determines
which fuel tank the mower is operating from. It is not
important which fuel tank the mower is using.
Left/Right Fuel Tank Switch
Figure 2-3
Blade Engagement Switch
Refer to Figure 2-2:
The Blade engagement switch engages the blade clutch
which engages deck blades. Pull the switch up to engage
and push switch down to disengage the blades.
Control Levers
Refer to Figure 2-4:
These levers control the mower’s speed, direction, neutral
lock and park brake. Levers are used to steer, accelerate,
decelerate, and change direction. The mower will not
move when the engine is on, drive pumps are operating
and the control levers are in the park brake position (out)
(Figure 2-5).
Control Levers
Figure 2-4
The Parking Brakes are applied by moving the control
levers from the Neutral Position (Figure 2-4) to an outward
position (Figure 2-5). Each rear wheel brake operates
independently of the other.
!
WARNING!
In the event of a system failure while mowing, engage both
parking brakes to stop or slow mower.
!
WARNING!
The parking brake is not designed to hold the mower on steep
slopes.
Control Levers in Parking Brake Position
Figure 2-5
Deck Lift Pedal
Refer to Figure 2-6:
The deck lift pedal is used to raise or lower the deck. Push
on the pedal to raise the deck and then place the deck
height locking pin into the desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
obstructions.
Deck Lift Pedal
Figure 2-6
IMPORTANT: Never engage blades with engine
running at high rpm or when the deck is under load.
Clutch, belts or deck could be damaged.
Control Levers
21041
20672
Control Levers
Deck Lift
Pedal
20670
Deck Height
Locking Pin