Land Pride PR2596 - Manual (Page 20)

18
Section 5: Maintenance & Lubrication
PR2572 & PR2596 Powered Rakes 314-132M 6/06/06
Land Pride
Table of Contents
Bottom and Top Seal Installation
If the bottom and top seals (#7) Figure 5-1 on page 17
need replacing refer to Figure 5-2 and Figure 5-3.
Top Bearing Seal Location
Figure 5-2
Bottom Bearing Seal Location
Figure 5-3
15833
15836
Friction Clutch PTO
Refer to Figure 5-4:
Powered Rake drive components are protected from
shock loads by a two plate friction clutch located
between the gearbox and the drive shaft.
The clutch should slip during operation to protect the
powered rake from excessive loads.
Prior to initial operation and after long periods of
inactivity, the Friction Clutch should be “run-in”.
1. Tighten all 4 nuts uniformly until the spring load is low
enough that the clutch slips freely with the PTO
engaged.
2. Engage the PTO until the clutch rotates one
revolution.
3. Turn nuts fully back. Clutch is ready for use.
Friction Clutch “Run In”
Figure 5-4
10103