Land Pride PR2596 - Manual (Page 26)

24
Section 7: Troubleshooting
PR2572 & PR2596 Powered Rakes 314-132M 6/06/06
Land Pride
Table of Contents
Section 7: Troubleshooting
Problem Solution
Machine makes intermittent clicking
noise Replace drive chain & or sprockets
Replace damaged gear
Replace drive chain
PTO vibrates Replace universal joint
Lower machine and readjust tractor lift stop
Gearbox noise is noticeable and
constant Allow time for break-in
Add oil
Replace gears
Oil leaking from gearbox Replace seals or gaskets
Drain to proper level
Roller will not turn Engage PTO
Repair drive chain
Reduce load to powered rake
Operating depth insufficient Raise gauge wheels
Increase tractor RPM
Replace roller
Clear roller
Clean roller
Roller gouging on the end Level powered rake
Set gauge wheel depth
Correct air pressure
Adjust tractor lower 3-point arms
Too much dirt going into the wind row or
dirt going over the top of the material
control blade Reduce ground speed
Raise material control blade
Lower gauge wheels
Too many rocks passing between
material control blade and the roller Lower material control blade
Adjust pitch
Adjust material control blade
Powered rake not following ground
contours Adjust the tractor top link
Roller balling up with soil Wait until soil dries
Powered Rake bumping on ground Clean roller
Rear Frame pivoting uncontrolled Replace shear pin