Plugs. see the accessories section of this manu, Accessories, Section c – Lincoln Electric POWER-ARC 4000 SVM103-A User Manual
Page 30: Options/accessories
OPTIONS/ACCESSORIES
LINCOLN ELECTRIC ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Lincoln
Distributor.
Power Plug Kit (K802T) – Provides three plugs, two
for the 120 volt duplex receptacle and one for the 240
volt receptacle.
Accessory Set (K875) – Includes the following:
• Twenty feet (6.1 meters) of #6 AWG electrode cable
• Fifteen feet (4.6 meters) of #6 work cable
• Headshield with No. 10 filter, work clamp
• Insulated electrode holder and sample electrodes
The cables are rated at 150 amps, 40% duty cycle.
Spark Arrester (K883-1) – A field-installed kit for the
8 HP Briggs & Stratton Cool-Bore
®
engine. The spark
arrestor attaches to the muffler to reduce the change
of sparks being emitted from the muffler.
Rotor Removal Kit (S20925) – A service kit with thru
and impact bolts for removing the generator rotor from
the tapered engine crankshaft.
BRIGGS AND STRATTON ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Briggs &
Stratton Distributor.
Foam Pre-cleaner (REF 271794) – Provides a foam
cleaner for replacement around the paper cartridge air
cleaner. Increases protection in extremely dusty or
dirty environments.
Oil Gard
®
Low Oil Shutdown Kit (REF 398182) –
Installs in the crankcase access port standard on all
POWER-ARC models. Senses low oil conditions and
automatically stops the engine. The engine cannot be
restarted until sufficient oil is added.
Super Lo-Tone
®
Muffler - Square (REF 494221) –
Replaces the round Lo-Tone muffler that comes
installed on the engine. Limits exhaust noise but
reduces maximum generator output by 200-300 watts.
Muffler Guard (REF 494868) – Installs onto the muf-
fler with a supplied bracket. Protects against acci-
dental contact with a hot muffler. Must not be used in
tandem with both a deflector and a spark arrester.
SEMIAUTOMATIC MIG WELDING
WITH A LINCOLN WELD-PAK 100
OR WELD-PAK 125
In addition to using the accessories/options listed
above, the POWER-ARC 4000 generator can supply
power to a Lincoln ELectric Weld-Pak 100 or Weld-
Pak 125 wire feed welder. The Weld-Pak comes with
all the supplies needed for Flux-Cored Arc Welding
(FCAW).
A K610-1 MIG (Metal Inert Gas) Conversion Kit is also
available for the Weld-Pak. The kit provides every-
thing needed for Gas Metal Arc Welding (GMAW) or
MIG processes. Contact your local authorized Lincoln
representative for details about the Weld-Pak and MIG
Conversion Kit.
POWER-ARC 4000
C-1
ACCESSORIES