Lucent Technologies MDW 9000/9010 - Manual (Page 15)

13
Often-Used Features
␣Callback␣
To program:
See Programming Buttons & Settings, p. 22.
You can use Callback when an outside line or inside extension is busy. Your phone must have at
least one SA button.
Use Callback to reach:
• Busy outside lines on Pool or SA buttons, when you dial the dial-out code and hear the fast
busy signal
• Busy extensions, when you dial and hear the busy signal
To use Callback when you hear the busy
(extension) or fast busy (outside line) signal:
1. Turn the phone on and press the button you
have programmed, OR
Press
# or the programmed Feature button
and dial 55.
2. If you are trying to reach an outside line, dial
the outside telephone number.
3. After you hear 5 short beeps, press the On/
Off button to hang up. When the line or
extension is free, you hear 2 short rings and
a long ring at an MDW 9000/9010 and 1 long
ring at an MDC 9000.
4. Press the On/Off button. You hear dial tone
and the system dials the call.
To cancel a Callback request:
1. Turn the phone on and press the same line
button you pressed when you tried to make
the call.
2. Press the Drop button.
3. Press the same line button again.
␣Call Waiting ␣
If Call Waiting is on, you hear a call-waiting tone when a call comes in and SA and ICOM buttons
are in use. This feature works only on SA and ICOM buttons, not on line buttons labeled with a
phone number. When a call is waiting, you hear a single beep (inside call) or 2 beeps (outside call).
To complete a call and answer a waiting call:
1. When you hear the call-waiting tone, press
the On/Off button to hang up.
2. When the phone rings, press the On/Off
button to answer the call.
To put a call on hold and pick up a waiting call:
1. Press the Hold button.
2. Press an ICOM Originate Only or SA
Originate Only button. (You must have one
of these buttons available to pick up the call.)
3. Press # or the programmed Feature button
and dial 87.
4. To return to the call on hold, press the
button with the fast-flashing triangle.
To turn Call Waiting on or off:
1. Turn the phone on and press the imprinted
Feat button; then dial 00.
2. Press any ICOM or SA button.
3. Dial ✻11 to turn Call Waiting on,
OR
Dial ✻✻11 to turn Call Waiting off.
4. Press the imprinted Feat button; then dial
00.